| Amplificateur intégré dual mono avec télécommande équipé d'un étage MM et by pass Home Theater. |
| |
| Output: |
| Power 250 Watts per channel into 8 Ohms (24dBW), 400 Watts per channel into 4 Ohms |
| Voltage, RMS 45 Volts 20Hz to 20kHz |
| Voltage, Peak-to-peak 127.3 Volts |
| Current peak-to-peak 75 Amps |
| Damping factor 140 |
| Output devices per channel 4 |
| Pre-out impedance : 50 Ohms |
| |
| Line inputs: |
| Total harmonic distortion + noise, 20Hz to 20kHz < 0.01% |
| Signal / noise ratio > 100dB 'A'-weighted |
| Input sensitivity for 250 Watts into 8 Ohms 330mV |
| Input impedance 220k Ohms |
| Overload margin 26dB |
| Channel separation > 70dB typical |
| Frequency response 20Hz to 20kHz, +0, -0.2dB |
| |
| Home Theatre Direct input |
| Input sensitivity 30dB gain (31.5 times) nominal |
| |
| Phono input: |
| Frequency response reference IEC RIAA - see graph below |
| Signal / noise ratio > 96dB 'A'-weighted |
| Input sensitivity 2.5mV (moving magnet) |
| Input impedance 47k Ohms |
| Overload margin 24dB |
| |
| General: |
| Inputs 4 pairs line level RCA connectors. |
| 1 pair (Home Theatre) direct power amplifier input RCA connectors. |
| 1 pair phono (moving magnet) RCA connectors. |
| Outputs 2 amplifier channels via 1 pair per channel binding posts. |
| 1 pair RCA audio outputs controlled by the volume. |
| 1 pair RCA tape record fixed line level output. |
| Power requirement 100 / 115 / 230Volts AC 50 / 60Hz (factory pre-set), |
| 700 Watts maximum into 8 Ohms, 35 Watts idle |
| Weight 16.6 kg, 36.6 lbs unit only, unboxed |
| 19.1 kg, 42.1 lbs in shipping carton |
| Dimensions 440 mm, 17.3 inches wide |
| 125 mm, 4.9 inches high including feet |
| 400 mm, 15.75 inches deep including terminals |
| Standard accessories IEC type mains lead (10-Amp type), |
| remote control (A5, universal type), |
| 2 batteries size LR03 or AAA, manganese alkaline type |
| |
MUSICAL FIDELITY A5
